1. LED lamp control system (80% in total)
Configure the KEY0 and KEY1 as external interrupts and use them to control the status of LED0 and LED1:
When press KEY0, toggle LED0 and output the status of LED0 by UART: “LED0 is On” or “LED0 is Off”.(20%)
When press KEY1, toggle LED1 and output the status of LED1 by UART: “LED1 is On” of “LED1 is Off”.(20%)
Use UART in non-blocking mode to control the on and off of LED0 and LED1 When receiving the message “Turn on LED0” from PC, turn on LED0.(10%) When receiving the message “Turn on LED1” from PC, turn on LED1.(10%) When receiving the message “Turn off LED0” from PC, turn off LED0.(10%) When receiving the message “Turn off LED1” from PC, turn off LED1.(10%)
2. Report (20% in total)
Complete the document “CS301-2021FALL-lab-ass1-report-SID-NAME”.
3. Notes
Use XCOM serial assistant to display the led status and send the control messages.
4. Submission demands
(1) Finish the assignment before DDL.
(2) Package the whole project into a compressed package and submit on Sakai site.
(3) Rename your report as “CS301-2021FALL-lab-ass1-report-SID-NAME.pdf” and submit on Sakai site.
